|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
ASSEMBLY
Assembly
1. If you will be placing the HTFS 2 stands on a hard surface, such as a wood or tile floor, attach four of the supplied self-adhesive rubber pads to the underside of the base in the recesses as indicated in the drawing. 6. Attach the mounting plate to the top of the column using two of the supplied screws. The mounting plate tab with the third screw hole should sit on the higher rim of the column.
Attaching the Speaker to the Stand
1. Unscrew the bolt that attaches the black shelf stand to the bottom of the speaker. Store the stand in a safe place in case it is needed for a future installation. The bolt will be used to attach the speaker to the floor stand mounting plate.
Place rubber pads or floor spikes here
Remove Stand
2. If you will be using the HTFS 2 stands on a carpeted surface, screw four of the supplied floor spikes into the base using the threaded inserts in the recesses as shown in the drawing. 3. Following the instructions on pages 9 through 12 of the owner�s manual provided with your HKTS system, thread the appropriate speaker cable through the hole in the center of the base, being careful to avoid the two screw holes. Then feed the cable through the length of the column from the bottom until it comes out the top. 4. Attach the column to the base using two of the supplied screws. 5. Thread the speaker cable through the hole in the center of the mounting plate, being careful to avoid the three screw holes.
15mm or 1/2"
2. Insert the speaker wires into the terminals on the bottom of the speaker, being careful to observe the correct polarity. 3. Place the speaker on top of the mounting plate with the remaining screw hole lined up with the threaded insert on the bottom of the speaker. 4. Insert the bolt that was used for the shelf stand up through the remaining screw hole and into the speaker. Repeat the assembly and speaker attachment processes for each floor stand in your system, and adjust the final speaker placement as indicated in the owner�s manual supplied with the speakers. You are now ready to enjoy your home theater system!
ASSEMBLY
3
|
|
|
> |
|
